Street lights are mainly used to provide vehicles and pedestrians with necessary visible lighting facilities, so how to wire and connect street lights? What are the precautions for installing street light poles? Let’s take a look now with street light factory TIANXIANG.
How to wire and connect street lights
1. Weld the power driver inside the lamp head, and connect the lamp head line to the 220V cable for use.
2. Separate the LED power driver from the lamp head and place the power driver at the lamp pole inspection door. After connecting the lamp head and the LED power driver, connect the 220V cable for use. Connect the positive to the positive and the negative to the negative, and connect them to the underground cable line accordingly. The light can be turned on when the power is turned on.
Precautions for installing street lights
1. Set up obvious warning signs around the construction site to remind passing pedestrians and vehicles to pay attention to the construction area to avoid accidents.
2. Construction workers should wear safety equipment such as safety helmets, non-slip shoes, and protective gloves to prevent accidental injuries.
3. The construction site is usually located next to the road, and construction workers should strictly abide by traffic rules to avoid traffic accidents. At the same time, pay attention to the safe distance from passing vehicles to ensure the safety of construction workers and vehicles.
4. When carrying out street light construction, construction workers should pay attention to electrical safety and avoid touching wires and electrical equipment. They should be familiar with the operating procedures of electrical equipment and be equipped with corresponding insulating tools to ensure electrical safety.
5. Avoid using open flames or flammable items, keep the construction site clean, and promptly clean up garbage and waste generated during construction to prevent fires.
6. The excavation size of the lamp pole foundation pit must comply with the design. For example, the foundation concrete strength grade must not be less than C20. If the cable protection pipe in the foundation passes through the center of the foundation, it will exceed the plane by 30-50 mm. The water in the pit should be removed before pouring concrete.
7. The longitudinal center line of the lamp installation and the longitudinal center line of the lamp arm should be consistent. When the horizontal horizontal line of the lamp is parallel to the ground, check whether it is skewed after tightening.
8. The efficiency of the lighting fixture is not less than 60%, and the lamp accessories are complete. Check whether there is mechanical damage, deformation, paint peeling, lampshade cracking, etc.
9. The lamp holder lead wire should be protected by a heat-resistant insulating tube, and the tail seat of the lampshade should be ensured to fit without gaps during the connection process.
10. Check whether the light transmittance of the transparent cover reaches more than 90%, and then check whether there are bubbles, obvious scratches and cracks on it.
11. The lamps are sampled for temperature rise and optical performance tests, which must comply with the relevant provisions of the current national lamp standards, and the testing unit should have a qualification certificate.
The relevant knowledge about how to wire and connect street lights and installation precautions is introduced here, and I hope it will be helpful to everyone. If you need to know more relevant knowledge, please continue to pay attention to the street light factory TIANXIANG, and more exciting content will be presented to you in the future.
Post time: Apr-16-2025